Custom Fit Fingerless Mitts

With only 3 measurements and a gauge swatch, you can knit any size mitts with any yarn you desire! Just fill in a few measurements and click the “Make my pattern” button.

Who are the mitts going to fit?

Who is this pattern for?

Measurements

Note for those who usually use fractions: Please use decimal numbers as follows.

¼ = .25, ½ = .5 and ¾ = .75

So 3 ¼ would be written 3.25, 2 ½ would be written 2.5, 1 ¾ would be written 1.75 etc

Would you like your pattern written in inches or cm?

inches

cm

Measure the person who will be wearing the mitts. You will need 3 measurements:

The circumference of the hand, excluding the thumb

The circumference of the thumb

The distance from the base of the thumb to the base of the base of the index finger

Gauge

Work out your gauge by knitting a stocking stitch swatch and measuring how many sts you get per 10 cm or 4 inches. Include the numbers after the decimal point, don’t round up or down to the nearest stitch.

Yarn and Needles

What size needles did you use?

What yarn did you use?

‘s Custom Fit Fingerless Mitts Pattern

Size: to fit hand circumference (excluding thumb)

Materials

Needles: A set of size double pointed needles and a set of DPNs one or two sizes smaller for the ribbing

Yarn:

Tension: sts per 10cm/4″ on needles

Abbreviations

M1 = Make 1 stitch by putting your needle under the thread that lies between stitches, twist it (to avoid making a hole), and knit it.

P2tog = Purl 2 stitches together.

Pattern

Using smaller needles, cast on sts, and join for knitting in the round. Place a marker at the beginning of the round.

Work 5cm or 2″ k1, p1 rib.

Change to larger needles and work 2.5cm or 1″ of stocking stitch (knit every round).

Make thumb gusset as follows:

K1, m1, k1, m1, k to end of round

Knit 1 round

K1, m1, k3, m1, k to end of round

Knit 1 round

K1, m1, k5, m1, k to end of round

Knit 1 round

Continue increasing in this manner (working 2 more stitches between the m1’s on every second round) until you reach “K1, m1, k, m1, k to end of round

Next round: K1, put next sts onto a holder, cast on 1 st, k to the end of the round.

Continue working rounds in stocking stitch for

Change to smaller needles and work in k1, p1 rib until knitting measures from the thumb opening. Cast off neatly in rib.

Thumb

Using smaller needles work k1, p1 rib across the stitches you put on a holder, beginning with a purl stitch, then pick up 3sts at the top of the thumb (where you cast on 1 st after finishing the thumb gusset).

Place a marker for the beginning of the round.

Next round: Work rib to the last 4sts, P2tog, k1, remove the end of round marker and purl the last stitch together with the 1st stitch of the next round. Replace the end of round marker.

Work 1.25cm or 1/2″ of k1, p1 rib (beginning with a knit stitch this time!), cast off loosely.

Finishing

Darn in all loose ends, wash and block.